ID Registration Cannot Be Completed

ID REGISTRATION CANNOT BE COMPLETED





Description
The ID of the transmitter installed in each wheel cannot be registered in the tire pressure monitoring system.
Inspect the transmitter or the tire pressure monitoring system circuit.




Diagnosis Procedure
1.TRANSMITTER WAKE-UP
Perform the transmitter wake-up. Work Procedure.
Is the transmitter wake-up completed?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK ACTIVATION TOOL
Check activation tool.
Is the inspection result normal?
YES - GO TO 3.
NO - Replace battery for activation tool, or repair or replace activation tool.
3.TRANSMITTER ID REGISTRATION
Perform transmitter ID registration. ID Registration.
Is transmitter ID registration completed?
YES - GO TO 4.
NO - Change the work location and perform ID registration again.
4.CHECK TIRE PRESSURE SIGNAL
With CONSULT-III
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. Stop the vehicle.
3. Select "DATA MONITOR" for "AIR PRESSURE MONITOR" with CONSULT-III.
4. Within 5 minutes after vehicle stopped, check that the tire pressures match the standard value.





Is the inspection result normal?
YES - INSPECTION END
NO - Change the work location, then GO TO 3.