System Description With Automatic Back Door

INTELLIGENT KEY SYSTEM


DOOR LOCK FUNCTION : System Description

Only when pressing the request switch, is it possible to lock and unlock the door by carrying the Intelligent
Key.

OPERATION DESCRIPTION
- When the BCM detects that each door request switch is pressed, it activates the outside key antenna and inside key antenna corresponding to the pressed door request switch and transmits the request signal to the
Intelligent Key. And then, checks that the Intelligent Key is near the door.
- If the Intelligent Key is within the outside key antenna detection area, it receives the request signal and transmits the key ID signal to the BCM via remote keyless entry receiver.
- BCM receives the key ID signal and compares it with the registered key ID.
- BCM lock/unlock each door (except back door) and fuel lid lock actuator and sounds Intelligent Key buzzer warning (lock: 2 times, unlock: 1 time) at the same time as a reminder.

OPERATION CONDITION
If the following conditions are satisfied, door lock/unlock operation is performed if the request switch is operated.






OUTSIDE KEY ANTENNA DETECTION AREA





The outside key antenna detection area of door lock/unlock function is in the range of approximately 80 cm (31.50 in) surrounding the driver and passenger door handles (1) and the back door request switch (2). However, this operating range depends on the ambient conditions.

SELECTIVE UNLOCK FUNCTION
When a LOCK signal is sent from door request switch (driver side or passenger side), all doors and fuel lid are locked.
When an UNLOCK signal is sent from door request switch (driver side or passenger side) once, driver's door and fuel lid are unlocked.
Then, if an UNLOCK signal is sent from door request switch (driver side and passenger side) again within 60 seconds, all other doors are unlocked.

HAZARD AND BUZZER REMINDER FUNCTION
During lock and unlock operation by each request switch, the hazard warning lamps and Intelligent Key warning buzzer blink or honk as a reminder.
When doors are locked or unlocked by each request switch, BCM sounds Intelligent Key warning buzzer as a reminder and blinks.

Operating Function of Hazard and Buzzer Reminder






How to Change Hazard and Buzzer Reminder Mode
CONSULT-III Function (BCM - Intelligent Key) With Automatic Back Door, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (With Automatic
Back Door)".

AUTO DOOR LOCK FUNCTION
When all doors are locked, ignition switch is in the OFF position, and key switch is OFF (Intelligent Key is not inserted in key slot), doors are unlocked with door request switch
When BCM does not receive the following signals within 60 seconds, all doors and fuel lid are locked.
- Door switch is ON (door is opened)
- Door is locked
- Ignition switch is ON (ignition switch is pressed)
- Key switch is ON (Intelligent Key is inserted in key slot)
Auto door lock mode can be changed in "AUTO LOCK SET" mode in "WORK SUPPORT". CONSULT-III Function (BCM - Intelligent Key) With Automatic Back Door, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (With Automatic Back Door)".

INTERIOR ROOM LAMP CONTROL
Intelligent Key system turns on interior lamp by receiving UNLOCK signal from door request switch. For detailed description, System Description.

LIST OF OPERATION RELATED PARTS
Parts marked with x are the parts related to operation.