Special Repair Requirement

INSPECTION AND ADJUSTMENT


ZERO POINT RESET : Special Repair Requirement

1.PERFORM ZERO POINT RESET
1. Perform zero point reset.

NOTE:
When performing zero point reset, be careful of the items described as per the following.
- Perform zero point reset after installing passenger seat to the vehicle
- Do not put any objects on passenger seat
- Do not apply excessive vibration to the vehicle
- Do not touch the vehicle
- Do not tilt the vehicle
2. Select start on "Zero point reset function" screen from, WORK SUPPORT of CONSULT-III "OCCUPANT
DETECTION".
3. "Zero point reset" starts.
- GO TO 2.
2.CONFIRMATION OF SETTING
1. Proceed to "Zero point reset function" screen from work support of CONSULT-III "OCCUPANT DETECTION".
2. Check that "Complete" or "Incomplete" is displayed on "Zero point reset status".

CAUTION:
- "Complete" is displayed on "zero point reset current status" if the seat is reinstalled by seat removal and installation, or "zero point reset" is already performed.
- "Zero point reset current status" displays "Incomplete" if a new seat is installed. When turning key switch ON without performing zero point reset, front passenger air bag OFF indicator turns ON.
When zero point reset is performed, front passenger air bag OFF indicator turns OFF.
- Air bag warning lamp blinks in user mode only.
- Air bag sensor unit does not record whether or not zero point reset is performed.
Is condition "ALREADY PERFORMED"?
YES - Print out "ZERO POINT RESET CURRENT STATUS" screen, and inspection end.
NO - Check condition as per the following, and perform zero point reset again.
- Passenger seat is occupied by an object.
- Excessive vibration is applied while performing zero point reset.
- Occupant detection system is malfunctioning.

NOTE:
If "Incomplete" is displayed on "zero point reset current status", zero point reset is not completed normally. Check the condition as per the following and perform zero point reset again.
- Passenger seat is occupied by an object.
- Excessive vibration is applied while performing zero point reset.
- Occupant detection system is malfunctioning.