Inspection and Adjustment

INSPECTION AND ADJUSTMENT


ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair Requirement


INITIALIZATION PROCEDURE
1. Disconnect the battery negative terminal or power window main switch connector. Reconnect it after a minute or more.
2. Turn ignition switch ON.
3. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open)
4. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at the fully closed position, keep pulling the switch for 3 seconds or more.
5. Initializing procedure is completed.
6. Inspect anti-pinch function.

CHECK ANTI-PINCH FUNCTION
1. Fully open the door window.
2. Place a piece of wood near fully closed position.
3. Close door glass completely with AUTO-UP.
- Check that glass lowers for approximately 150 mm (5.9 in) or for 2 seconds without pinching piece of wood and stops.
- Check that glass does not rise when operating the power window main switch while lowering.

CAUTION:
- Perform initial setting when auto-up operation or anti-pinch function does not operate normally.
- Check that AUTO-UP operates before inspection when system initialization is performed.
- Never check with hands or other body parts because they may be pinched. Never get pinched.
- It may switch to fail-safe mode if open/close operation is performed continuously without fully closing. Perform initial setting in that situation. Front And Rear Window Anti-Pinch
- Finish initial setting. Otherwise, next operation cannot be done.
1. Auto-up operation
2. Anti-pinch function