Special Repair Requirement

INSPECTION AND ADJUSTMENT


ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement


WORK PROCEDURE WHEN REPLACING CONTROL UNIT
1.PERFORM ZERO POINT RESET
Perform zero point reset. Special Repair Requirement.
Is zero point reset performed normally?
YES - INSPECTION END
NO - Check condition as per the following, and perform zero point reset again.
- Passenger seat is occupied by an object.
- Excessive vibration is applied while performing zero point reset.
- Occupant detection system is malfunctioning.

NOTE:
If "Incomplete" is displayed on "zero point reset current status", zero point reset is not completed normally. Check the condition as per the following and perform zero point reset again.
- Passenger seat is occupied by an object.
- Excessive vibration is applied while performing zero point reset.
- Occupant detection system is malfunctioning.