Removal And Installation

EXHAUST SYSTEM


Removal and Installation


REMOVAL
- Disconnect each joint and mounting using power tool.
- Remove heated oxygen sensor 2, as follows:.





- Using heated oxygen sensor wrench [SST: KV10114400] (C), removal heated oxygen sensor 2.

A : Bank 1
B : Bank 2
Arrow : Vehicle front

INSTALLATION
Note the following items, and install in the reverse order of removal.
- Temporarily tighten bolts and nuts when installing exhaust pipe assembly. Tighten them to the specified torque when connecting the vehicle rear to the vehicle front.

CAUTION:
- Always replace exhaust tube gaskets with new ones when reassembling.
- If heat insulator is badly deformed, repair or replace it. If deposits such as mud pile up on the heat insulator, remove them.
- When installing heat insulator avoid large gaps or interference between heat insulator and each exhaust pipe.
- Remove deposits from the sealing surface of each connection. Connect them securely to avoid gases leakage.
- Check each part for unusual interference, and then tighten them to the specified torque.
- When installing each mounting rubber, avoid twisting or unusual extension in up/down and right/left directions.