Removal And Installation

CRASH ZONE SENSOR


Removal and Installation


WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more.
- Never use the air tools or electric tools for servicing.

REMOVAL
1. Remove the front under cover. Removal And Installation.
2. Disconnect the crash zone sensor harness connector.
3. Remove the crash zone sensor fixing nut, and then remove crash zone sensor.

CAUTION:





- Never impact the crash zone sensor.
- Replace the crash zone sensor if it has been dropped or sustained an impact.
- Replace the crash zone sensor of deployed driver air bag and deployed front passenger air bag.

INSTALLATION
Note the following item, and install in the reverse order of removal.

CAUTION:
- Never use the old fixing nut after removal, replace with the new nut.
- Never damage the harness connector while installing.
- If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT-III. On Board Diagnosis Function or Diagnosis System (Air Bag).
- After the work is completed, check that no system malfunction is detected by air bag warning lamp.