Work Procedure

STANDARD VEHICLE HEIGHT SETTING


Work Procedure

1.CLEAR STANDARD VEHICLE HEIGHT
With CONSULT-III
1. Lift up the vehicle.

CAUTION:
Check that tires never contact the ground.
2. Start the engine.
3. Select "COMPRESSOR" in "Active Test" in "E-SUS".
4. Touch "ON" and wait 60 seconds or more.
5. Touch "OFF".
6. Select "CLEAR HEIGHT INI" in "Work Support" in "E-SUS".
7. Touch "Start".
8. Touch "Clear".

NOTE:
CONSULT-III continues indicating "EXECUTING". The completion of the standard vehicle height erasing can be checked by the CK SUSP indicator lamp ON condition.
Does CK SUSP indicator lamp turn ON?
YES - GO TO 2.
NO - Perform step 1 again.
2.ADJUST STANDARD VEHICLE HEIGHT
With CONSULT-III
1. Select "ADJUST HEIGHT INI" in "Work Support" in "E-SUS".
2. Touch "Start".
3. Touch "Initial 1".

NOTE:
CONSULT-III continues indicating "EXECUTING". The completion of the standard vehicle height adjustment can be checked by the CK SUSP indicator lamp OFF condition.
Does CK SUSP indicator lamp turn OFF?
YES - GO TO 3.
NO - Perform step 1 again.
3. ADJUST VEHICLE HEIGHT
With CONSULT-III
1. Lift down the vehicle.

CAUTION:
Check that the lift is fully lowered.
2. Select "STANDARD HEIGHT LEVEL" in "Work Support" in "E-SUS".
3. Touch "Start".
4. Touch "Revert" and wait 120 seconds or more.
5. Although CONSULT-III continues indicating "EXECUTING", select "VHCL HGT CNVSN VL" in "Data Monitor" in "E-SUS".
Is value within -15 � 15 mm?
YES - GO TO 4.
NO - Perform step 1 again.
4.CHECK DTC
With CONSULT-III
Select "Self Diagnostic Results" in "E-SUS".
Is any DTC detected?
YES - Testing and Inspection.
NO - SETTING END