ID Registration

ID REGISTRATION


Work Procedure

1.CONFIRMATION OF TRANSMITTER ACTIVATION TOOL USE
Check method of ID registration procedure.
Is the transmitter activation tool (J-45295) used for the transmitter ID registration procedure?
YES - GO TO 2.
NO - GO TO 3.
2.TRANSMITTER ID REGISTRATION PROCEDURE (WITH THE TRANSMITTER ACTIVATION TOOL)
With CONSULT-III
1. Turn the ignition switch ON.
2. Display the "WORK SUPPORT" screen for "AIR PRESSURE MONITOR" and select "ID REGIST".





3. Press the transmitter activation tool (J-45295) (1) against the side of the tire at the location closest to the transmitter.
4. Wait until the indicator lamp turns OFF (approximately 5 seconds).

CAUTION:
Perform the ID registration procedure starting from the vehicle front left wheel, then repeat the procedure in the order of the front right wheel, rear right wheel, and rear left wheel.
5. When ID registration is completed, check the following pattern at each wheel.





6. After the ID registration procedure for all wheels is completed, press "End" to end ID registration, and check that ID registration for all wheels is completed.
Is the check result normal?
YES - ID registration END.
NO - Perform the self-diagnosis for "AIR PRESSURE MONITOR". Testing and Inspection.
3.TRANSMITTER ID REGISTRATION PROCEDURE (WITHOUT THE TRANSMITTER ACTIVATION TOOL)
With CONSULT-III
1. Display the "WORK SUPPORT" screen for "AIR PRESSURE MONITOR" and select "ID REGIST".
2. Adjust the tire pressure for all wheels to match the list below.





3. Drive the vehicle at a speed at more than 40 km/h (25 MPH) for 3 minutes or more, then perform the transmitter ID registration procedure.
4. After ID registration for all wheels is completed, press "End" to end ID registration.





5. Adjust the tire pressures for all wheels to the specified value. [1][2]Specifications.
Is ID registrations for all wheels completed?
YES - ID registration END.
NO - Perform the self-diagnosis for "AIR PRESSURE MONITOR". Testing and Inspection.