Removal And Installation

REAR DOOR GLASS


Removal and Installation


REMOVAL
1. Remove rear door finisher. Removal And Installation.
2. Remove rear door inside seal.
3. Remove rear door outside molding. .
4. Remove rear door pull handle bracket mounting bolts and remove it.
5. Disconnect rear door speaker harness connector.
6. Remove the rear door sealing screen with a cutter tool.

NOTE:
Cut the butyl-tape so that some parts of the butyl-tape do not remain on the rear door sealing screen, if the sealing screen is reused.
7. Reconnect the rear door power window switch.





8. Operate the power window switch to raise or lower the door window until the glass mounting bolts can be seen.
9. Remove the rear door glass mounting bolts.

Arrow: Bolt





10. Raise rear door glass up and hold it with a suction lifter (A).
11. Disconnect rear door power window motor harness connector.
12. Remove rear door regulator mounting nuts.
13. Remove rear door power window motors mounting bolts.
14. Remove rear door regulator from rear door panel.
15. Securely place rear door glass down inside rear door panel.
16. Remove rear door glass run.





17. Remove rear door sash mounting bolts and screw, and then pull it up to remove.

CAUTION:
Be careful not to scratch or damage rear door glass with rear door sash.





18. Remove rear door glass from rear door panel as shown by the figure.





19. Slide partition glass toward the vehicle and remove it as shown in the figure.

INSTALLATION
Install in the reverse order of removal.