DCA

U1000 CAN COMM CIRCUIT

ADAS CONTROL UNIT : Description


CAN COMMUNICATION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control units, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H, CAN-L) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads the required data only.
CAN communication signal chart. CAN Communication Signal Chart.

ITS COMMUNICATION

- ITS communication is a multiplex communication system. This enables the system to transmit and receive large quantities of data at high speed by connecting control units with 2 communication lines.
- ITS communication lines adopt twisted-pair line style (two lines twisted) for noise immunity.


ADAS CONTROL UNIT : DTC Logic


DTC DETECTION LOGIC






NOTE:
If "U1000" is detected, first diagnose the CAN communication system.


ADAS CONTROL UNIT : Diagnosis Procedure


1. PERFORM THE SELF-DIAGNOSIS

1.Turn the ignition switch ON.
2.Turn the DCA system ON, and then wait for 30 seconds or more.
3.Perform "All DTC Reading" with CONSULT.
4.Check if the "U1000" is detected as the current malfunction in "Self Diagnostic Result" of "ICC/ADAS".
Is "U1000" detected as the current malfunction?
YES- Trouble Diagnosis Flow Chart.
NO- Intermittent Incident.


ACCELERATOR PEDAL ACTUATOR : Description


ITS COMMUNICATION

- ITS communication is a multiplex communication system. This enables the system to transmit and receive large quantities of data at high speed by connecting control units with 2 communication lines.
- ITS communication lines adopt twisted-pair line style (two lines twisted) for noise immunity.


ACCELERATOR PEDAL ACTUATOR : DTC Logic


DTC DETECTION LOGIC








ACCELERATOR PEDAL ACTUATOR : Diagnosis Procedure


1. PERFORM THE SELF-DIAGNOSIS

1.Turn the ignition switch ON.
2.Turn the DCA system ON, and then wait for 2 seconds or more.
3.Perform "All DTC Reading" with CONSULT.
4.Check if the "U1000" is detected as the current malfunction in "Self Diagnostic Result" of "ACCELE
PEDAL ACT".
Is "U1000" detected as the current malfunction?
YES- Trouble Diagnosis Flow Chart.
NO- Intermittent Incident.