California
System Diagram (California):
PURPOSE
The Closed Loop Emission Control System is a computerized fuel, ignition and emission control system designed to maintain fuel economy, good driveability and reduced vehicle emissions.
OPERATION
Feedback Control
An Electronic Control Module (ECM) monitors data from various sensors and controls functions such as air/fuel ratio, emission control devices and on-board diagnostics.
The ECM is a computer that judges air/fuel ratio as rich or lean according to oxygen sensor output voltage. Based on oxygen sensor and other input data, the ECM generates a controlling signal to the fuel injectors that regulates "ON" time. Because fuel pressure remains constant, the ECM controls air/fuel ratio adjustments by varying injector "ON" time.
When operating in "Open Loop," the ECM defaults to preprogrammed values for air/fuel ratio control. The system is in "Open Loop" before the oxygen sensor has warmed up to operating temperature. When operating in "Closed Loop," the ECM continually adjusts air/fuel ratio according to oxygen sensor input and operating information received from various other sensors.
Self-Diagnostics
This system incorporates self-diagnostic capability that is monitored via a dash mounted "Check Engine" light. When the system detects a fault in a monitored component and/or circuit, the light will come on and stay on (while the engine is running), alerting the driver to seek service. With intermittent problems, the light may come on and then go out, but a trouble code will be stored in ECM memory if correct parameters are met. The technician can then extract trouble codes from the ECM that will aid in the performance of efficient troubleshooting and repair.
Fail-Safe Operation
To give an extra margin of safety in the event of system failure, the output of the ECM will automatically switch to fail-safe mode if a fault is detected in any of these components and/or systems:
- Oxygen sensor
- Coolant temperature sensor
- Throttle valve switch system
- Air flow sensor system
If a malfunction develops in the micro computer within the control unit, the back-up control system will maintain the minimum necessary ECM functions to permit vehicle operation.
LIST OF COMPONENTS
Components can be grouped as ECM input and output devices. Input devices control or produce voltage signals monitored by the ECM. Output devices are components controlled by the ECM.
INPUT DEVICES
Air flow sensor (codes 61 & 62)
Oxygen sensor (codes 13, 44 & 45)
Crank angle sensor (code 41)
Coolant temperature sensor (codes 14 & 15)
Throttle valve switch (manual trans.) (codes 21, 43 & 65)
Throttle position sensor (auto. trans.)
Vehicle speed sensor (code 63)
EGR gas temperature sensor (code 34)
Battery voltage
Inhibitor switch
Ignition switch
Starter switch (code 22)
A/C switch
OUTPUT DEVICES
AIR VSV
"Check Engine" light
On-board diagnostics
Canister purge VSV (codes 26 & 27)
Fuel injectors/FI system (codes 33 & 64)
Ignition coil/power transistor (codes 23, 35 & 54)
EGR system/VSV and duty solenoid (CA only) (code 32)
Air regulator
Pressure regulator (fuel) VSV (codes 25 & 53)
ECM (abnormal LSI, codes 51 & 52)