Keyless Entry: Service and Repair

Programming the Transmitter

NOTES:

The system uses a stacking-type memory that accepts up to four transmitters. If you program a fifth transmitter, the memory for the first transmitter is pushed out, and it will no longer work.

To clear a lost or stolen transmitter from the system's memory, program a transmitter four times, This will remove the missing transmitter from memory, since only four transmitter codes can be accepted.

Another way to clear a lost or stolen transmitter is to erase all transmitter codes and then reprogram them. To do this, refer to the security system owner's manual.






1. Move the driver's seat forward, and locate the security system control unit mounted on the floor, underneath the seat.

2. Turn the ignition switch on.

3. Press and hold the green programming button on the side of the control unit with a pen or pencil. When the security system LED on the instrument panel comes on, release the programming button. (Steps 3 and 4 must be done within 5 seconds of each other.)

4. Press and release the top button on the transmitter. Check that the LED goes out, the siren chirps once, and the front marker lights flash to confirm that the transmitter's code was accepted by the control unit.

5. If you have other transmitters to program, repeat steps 3 and 4.

6. Turn the ignition switch off to exit the programming mode.

Batteries for the Transmitter

The battery number is CR2025. One battery per transmitter is needed.