With TECH 2

Tech 2 Scan Tool

IMPORTANT: Do not clear DTCs unless directed to do so by the service in formation provided for each diagnostic procedure. When DTCs are cleared, the Freeze Frame and Failure Record data which may help diagnose an intermittent fault will also be erased from memory.

If the fault that caused the DTC to be stored into memory has been corrected, the Diagnostic Executive will begin to count the "warm-up' cycles with no further faults detected, the DTC will automatically be cleared from the PCM memory.

To clear Diagnostic Trouble Codes (DTCs), use the diagnostic Scan tool "clear DTCs" or "clear information" function. When clearing DTCs follow instructions supplied by the tool manufacturer.

From 98 MY, Isuzu dealer service departments are recommended to use the Tech 2 scan tool. Please refer to the Tech 2 user guide.

Tech 2 is a 12 volt system. Do not apply 24 volt.

After connecting and/or installing, the Vehicle Communications Interface (VCI) module, PCMCIA card and DLC connector to the Tech 2, connect the tool to the vehicle DLC.

Make sure the Tech 2 is powered OFF when removing or installing the PCMCIA card.

The PCMCIA card has a capacity of 10 Megabytes which is 10 times greater than the memory of the Tech 1 Mass Storage Cartridge.

The Tech 2 has the capability of two snapshots.

The PCMCIA card is sensitive to magnetism and static electricity, so care should be taken in the handling of the card.

The Tech 2 can plot a graph when replaying a snapshot.

Always return to the Main Menu by pressing the EXIT key several times before shutting down.

To clear Diagnostic Trouble Codes (DTCs), open Application Menu and press "F1: Clear DTC Info".