Keyless Entry Module: Service and Repair

Anti-theft & Keyless Entry Control Unit

Removal

1. Disconnect the battery ground cable.
2. Remove the front console assembly.
- Refer to the Instrument Panel Assembly in Body Structure.

3. Remove the lower cluster assembly.
- Refer to the Instrument Panel Assembly in Body Structure.

4. Disconnect the connector (2).




5. Remove four screws to remove the anti-theft & keyless entry control unit with bracket (1).




6. Remove two nuts from the anti-theft & keyless entry control unit with bracket (3) to remove the anti-theft & keyless entry controller (4).

Installation

To install, follow the removal steps in the reverse order.

Anti-Theft & Keyless Entry Control Unit/Transmitter Replacement

Anti-Theft & Keyless Entry Control Unit Replacement
1. Remove and install the control unit.
- Refer to Anti-theft & Keyless Entry Control Unit Removal and Installation.

2. Register ID code.
- Refer to ID Code Registration in this section.

3. Check that the keyless entry system works normally.