TECH 2 Scan Tool

Scan Tool
The Tech 2 is used to read and clear SRS Diagnostic Trouble Codes (DTCs). Refer to the Tech 2 Operator's Manual for specific information on how to use the Tech 2.




J-35616-A Connector Test Adapter Kit
The J-35616-A Connector Test Adapter Kit must be used whenever a diagnostic procedure requests checking or probing a terminal. Using the appropriate adapter will ensure that no damage to the terminal will occur from the Digital Multimeter (DVM) prove, such as spreading or bending. The adapter will also give an idea of whether contact tension is sufficient, helping to find an open or intermittent open due to poor terminal contact.




J-42986 SRS Deployment Tool
The J-42986 Supplemental Restraint System (SRS) Deployment Tool must be used for deployment of the undeployed air bag.




J-42987 SRS Adapter For Load Tool
The J-42987 SRS Adapter be used for connect previous load tool to new SRS system when inspect SRS system harness.




J-41497 SRS Deployment Fixture
The J-41497 SRS Deployment Fixture must be used for deployment of the undeployed passenger side air bag.




Tech 2 Scan Tool
From 1999 VehiCROSS (VX), dealer service departments are recommended to use Tech 2. Please refer to Tech 2 scan tool user guide.

Getting Started
Before operating the Isuzu PCMCIA card with the Tech 2, the following steps must be performed:

1. The Isuzu 98 System PCMCIA card (1) inserts into the Tech 2 (5).
2. Connect the SAE 16/19 adapter (3) to the DLC cable (4).
3. Connect the DLC cable to the Tech 2 (5)
4. Mark sure the vehicle ignition is oft.




5. Connect the Tech 2 SAE 16/19 adapter to the vehicle Data Link Connector (DLC).
6. The vehicle ignition turns on.




7. Verify the Tech 2 power up display.

NOTE: The RS232 loop back connector is only to use for diagnosis of Tech 2 and refer to user guide of the Tech 2.







Operating Procedure
The power up screen is displayed when you power up the tester with the Isuzu systems PCMCIA card. Follow the operating procedure.