Body - Revised Liftgate Lock Cylinder Replacement
TSB SB06-11-S003Revised Liftgate Lock Cylinder Replacement (Service Manual Revision)
ISSUE DATE: MARCH 22, 2006
Affected Vehicles
^ 2003-2006 Isuzu Ascender (US)
Service Information
This bulletin is being issued to revise the Lock Cylinder Replacement - Liftgate procedure in the Body Rear End sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.
NOTE:
Information released on paper and electronic format prior to bulletin release cannot be updated. For the most current and up to date information refer to IsuzuONE.com.
When replacing the liftgate lock cylinder, removal of the rear window wiper motor, if equipped, is required.
Service Procedure
LOCK CYLINDER REPLACEMENT - LIFTGATE
Removal Procedure
1. Remove the rear wiper motor. Refer to Wiper Motor Replacement - Rear.
2. Remove the lock rod from the lock cylinder.
3. Remove the C clip from the groove in the lock cylinder.
4. Remove the lock cylinder from the liftgate.
Installation Procedure
1. Install the lock cylinder to the liftgate.
2. Install the C clip to the groove in the lock cylinder.
3. Install the lock rod to the lock cylinder.
4. Install the rear wiper motor. Refer to Wiper Motor Replacement - Rear.
Disclaimer