Oil Pump Cover Assemble
Oil Pump Cover AssembleTools Required
^ J38735-3 Stator Shaft Seals Installation Pusher
^ J39855 Stator Shaft Seal Installer
1. Using the J39855-1 which is part of kit J39855 and the J38735-3, install the stator shaft oil seal rings (230).
2. Place J39855-2 which is part of kit J39855 over the seals.
3. Leave J39855-2 which is part of kit J39855 on the stator shaft until just before the pump is to be installed into the transmission.
4. Install the pressure relief ball (228) and pressure relief spring (229).
5. Install the pressure relief bolt rivet (227).
6. Install the oil pump cover screen seal (231) on the oil pump cover screen (232).
7. Install the oil pump cover screen (232) into the pump cover.
8. Install the converter clutch valve inner (225) and outer (226) springs.
9. Install the converter clutch valve (224).
10. Install the stop valve (223) and the oil pump converter clutch valve retaining ring (222).
11. Install the pressure regulator valve (216).
12. Install the pressure regulator isolator spring (218) and the pressure regulator valve spring (217).
13. Install the reverse boost valve (219) in the reverse boost valve sleeve (220).
14. Install the reverse boost valve and sleeve in the pump cover.
15. Install the oil pump reverse boost valve retaining ring (221).