Key Code - Systems Identification

91isuzu02

BULLETIN NUMBER SB91-14-001


ISSUE DATE February 7, 1991


GROUP MISCELLANEOUS


1990-91 PICKUP (TF) AND RODEO (UC) KEY SERVICE PROGRAM (This Service Bulletin supercedes SB89-14-006.)


AFFECTED VEHICLES

1990-91 Pickup (TF) and Rodeo (UC) models.

SERVICE INFORMATION

1990-91 Pickups use two different key code systems, each requiring different code cutting equipment:

- Pickups manufactured in Japan (VINs starting with JAA) use N-series codes.

- Pickups manufactured in the U.S.A. (VINs starting with 4S1) use D-series codes.

All Rodeos use the D-series key code system, same as Pickups manufactured in the U.S.A.

Curtis Key Service Master Kit No. 15B-47 cutter (with green casting) is used for all Rodeos and 1990-91 Pickups. Update Kits, which contain all mateiials except a key cutter, are required as follows:


- Update Kit No. 20505 for Pickups manufactured in the U.S.A., and for all Rodeos.

- Update Kit No. 20436 for Pickups manufactured in Japan.

It is important that the appropriate code cutting equipment and key blanks are used. A miscut key may stick in the ignition switch in the Start position, resulting in damage to the starter system. If using a pre-cut key blank, use a key blank with the deepest cut in first position at the shoulder of the key.

Additional information on Curtis' 1991 Isuzu Key Service Program can be obtained by contacting Curtis Industries at (216) 951-2400.