Coil Assembly

Figure 6B-1 - Sensor to Crankshaft Reluctor Relationship, Ignition Coil Assembly,:

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Raise vehicle and suitably support.
3. 1CM electrical connector.
4. Spark plug cables. (Note proper relationship of the cables to the coils.)
5. Ignition coil assembly to block bolts (3).
6. Ignition coil assembly from engine.

INSTALL OR CONNECT
1. Ignition coil assembly to engine
2. Ignition coil assembly to block bolts (3)

3. Tighten ignition coil assembly attaching bolts to 20-30 Nm (15-22
ft. lbs.)

4. Spark plug cables to proper coils
5. ICM electrical connector
6. Lower the vehicle
7. Negative battery cable