Electronic Brake Control Module

Electronic Brake Control Module (EBCM):

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Four electrical connectors.
3. Four T-25 Torx bolts.
4. Electronic Brake Control Module (EBCM) from Brake Pressure Modulator Valve (BPMV). A light amount of force may be necessary to remove the EBCM.

NOTE:
^ Do not pry on the EBCM or BPMV with a mechanical aid. Excessive force will cause damage to the EBCM.
^ Do not reuse the EBCM gasket or mounting bolts. Always install a new gasket, and mounting bolts with a new EBCM.

^ Clean Top of the BPMV with a clean, dry cloth.

INSTALL OR CONNECT
1. New EBCM gasket onto BPMV.

NOTE: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

2. EBCM to BPMV.

^ Inspect Gasket for correct alignment.

3. Four new EBCM bolts.

^ Tighten Four bolts to 5 Nm (39 inch lbs.) in an X pattern.

4. Four electrical connectors.
5. Negative battery cable.
6. Verify bulb check.
7. Revise tire calibration using Scan Tool.