Accelerator Pedal Cable

REMOVAL




1. Loosen the adjusting nut (5) on the cable bracket mounted on the common chamber.
2. Remove cable clip (3).
3. Disconnect accelerator pedal (AP) control cable (6). (on throttle valve side)
4. Disconnect AP control cable (1). (on AP pedal (7) side)
5. Remove molding cap (2).
6. Remove AP control cable (4).

INSPECTION

Check the following items, and replace the control cable if any abnormality is found:
^ The control cable should move smoothly.
^ The control cable should not be bent or kinked.
^ The control cable should be free of damage and corrosion.

INSTALLATION




1. Install AP control cable (4).
2. Install molding cap (2).
3. Connect AP control cable (1). (on AP side)
4. Connect AP control cable (6). (on throttle valve side)
5. Install cable clip (3).
6. Install adjusting nut(s).