Accumulator: Service and Repair

DISASSEMBLY





1. Snap ring.
- Install cover compressor on adapter case. Compress piston cover. Remove snap ring.
Compressor: J-38559-A or equivalent.





2. Cover.
- Install cover remover to center hole of cover.
- Use slide hammer J-23907 or equivalent to remove cover.
over remover: J-41096 or equivalent
Adapter: J-38584 or equivalent
3. Spring
4. Piston

INSPECTION AND REPAIR
Visual Check: If any damage, deformation or wear is found in a return spring, piston or piston cover, replace it.

ASSEMBLY





1. Piston (4)
- Place the fitter into adaptor case and push the piston into position, using suitable diameter tube.
Piston fitter: J-38553 or equivalent
2. Spring (3)





3. Cover (2)
- Install-cover, using compressor tool J-38559-A or equivalent.
4. Snap ring (1)
- Install snap ring in groove.