Windshield Wiper Arm/Blade

Removal




1. Pry the cap(2) off with the tip of a screwdriver.
2. Remove the nut(3).
3. Remove the wiper/blade(1).

Installation
To install, follow the removal steps in the reverse order, noting the following points.
1. Wiper arm/blade
^ Before installing the wiper arm/blade to the shaft, confirm that the motor stops at the auto-stop position.




^ Set the wiper arm/blade so that the tips of both blades are positioned about 35 mm (1.37 in) from the upper edge of the cowl cover as shown.
^ Tighten the nuts to the specified torque.
Torque: 31 N.m (23 lb ft)