Control Panel Assembly and/or Control Cables

CONTROL LEVER ASSEMBLY AND / OR CONTROL CABLE:

CONTROL LEVER ASSEMBLY AND / OR CONTROL CABLE


Removal
1. Disconnect the battery ground cable.
2. Remove instrument panel driver lower cover assembly.
3. Remove meter cluster assembly.
4. Remove glove box.
5. Remove the control lever attaching screws.




6. Pull the control lever assembly out and disconnect the fan switch and air conditioning switch connectors.
7. Remove control level assembly.




8. Disconnect control cables at each unit side.

Installation
To install, follow the removal steps in the reverse order, noting the following points:




1. Adjust the control cable.
- Air source control cable.
1. Slide the control lever to the left (CIRC position).
2. Connect the control cable at the CIRC position of the link unit of the blower assembly and secure it with the clip.
- Temperature control cable.
1. Turn the control knob to the left (MAX COLD position).
2. Connect the control cable at the COLD position of the temperature control link of the heater unit and secure it with the clip.
- Air select control cable
1. Turn the control knob to the right (DEFROST position).
2. Connect the control cable at the DEFROST position of the mode control link of the heater unit and secure it with the clip.
2. Check the control cable operation.