Front Pump Seal

Removal
1. Remove transmission assembly with transfer case from the vehicle.
2. Remove torque converter from converter housing.





3. Remove three screws and oil seal ring from converter housing.

Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Apply clean ATF to the new oil seal ring lip.
^ Install oil seal ring to converter housing. Tighten the screws to the specified torque.
Torque: 3 Nm (26 inch lbs.)
2. Install torque converter to converter housing.
3. Install transmission assembly with transfer case to the vehicle. Refer to Removal and Installation; Transmission (With Transfer Case).