Rear Door Panel: Service and Repair

Rear Door Trim Panel

Rear Door Trim Panel And Associated Parts:

Removal

1. Disconnect the battery ground cable.
2. Remove the regulator handle(1).
- Pull the hook(2) out and remove the regulator handle.







3. Remove the one screw from the pullcase.







4. Remove the inside handle fixing screw.

CAUTION: Take care not to apply excessive force on the inside handle link, lest this link be elongated, which could make it impossible to operate the door with the inside handle.

5. Remove the rear door corner garnish.
6. Remove the door trim panel.
- Pull out the eight clip positions from the door panel.







- Disconnect the power window switch and courtesy light connectors to lift the trim panel and unlock the engagement of the waist seal section, then pass the inside lever through the mounting hole of the trim panel, and detach the trim panel.

7. Remove the inside handle.
8. Remove the power window switch.
- Remove the fixing screws of switch from backside of rear door trim.

Installation

To install, follow the removal steps in the reverse order.