Shift Cable: Service and Repair

SELECT CABLE

Removal
1. Set selector lever in "P" position.
2. Remove transfer control lever knob, lower cluster assembly, rear console, center console, selector lever knob and cover.





3. Disconnect inner cable by pulling projection on pin.





4. Press down claws and disconnect cable assembly.
5. Disconnect PCM harness connectors and remove nuts that fasten grommet in select cable assembly.





6. Disconnect inner cable.





7. Slide sleeve and disconnect cable assembly.





8. Pull lock.
9. Draw select cable assembly into the interior side.

Installation
1. Set selector lever in "P" position.
2. Let out select cable transmission side end from floor hole.





3. Fit outer cable into bracket in selector lever assembly.





4. Set inner cable end in selector lever and push pin into selector lever hole and inner cable end.





5. Check that lock projects.
6. Connect adjust end fitting attachment to the bracket on transmission.





7. Connect inner cable to select lever.





8. Push lock into adjust end fitting attachment.
9. Install grommet.