Rear Seat Assembly (SWB)

Rear Seat Assembly (SWB)

Rear Seat Assembly And Associated Parts:

Removal

1. Fold the rear seat backs forward.
- Pull up on the left and right release knobs.

2. Remove the rear seat leg covers.
- Remove the one screw and clip from each.

3. Remove the rear seat assembly.
- Remove the two sets of two fixing bolts from left and right sides, then pull on the seat lock strap to release the seat lock.

4. Remove the device covers (left and right).
- Remove the three screws from each.

5. Remove the release knobs (left and right).
6. Remove the rear seat back assemblies (left and right).
- Remove the two sets of two reclining device fixing bolts from the sides of the seat backs.

7. Remove the headrests.
8. Remove the trim covers.
9. Remove the guide holders.
10. Remove the reclining devices.
- Remove the two sets of two fixing bolts from the sides of the seat cushions.

11. Remove the rear seat legs (left and right).
12. Remove the support covers (left and right).
- Remove the three screws from each.

13. Remove the seat lock covers (left and right).
14. Remove the seat lock assemblies and the rear seat belt buckle assemblies (left and right).
- Remove the two sets of two fixing bolts.

15. Remove the free hinge cover.

Installation

To install, follow the removal steps in the reverse order, noting the following points:

1. Tighten the seat lock assemblies and the rear seatbelt buckle assemblies to the specified torque.

Torque: 39 N.m (29 lb ft)

2. Tighten the reclining devices to the specified torque.

Torque: 46 N.m (34 lb ft)

3. Tighten the rear seat assembly fixing bolts to the specified torque.

Torque: 39 N.m (29 lb ft)