Compressor Sealing Washers

IMPORTANT: Use the correct washers.





1. Clean all of the sealing surfaces with a lint-free rag in order to prevent dirt or foreign material from getting into the following sealing surface components:
- The washers
- The hose block
- The compressor ports




2. Install the sealing washer onto the pilots of the suction/discharge fitting.
Ensure that the washers are seated against the surface of the block fitting.
3. Install the hose block to the compressor.
Ensure that the sealing washers are seated within the compressor's machined surfaces.

NOTE: Refer to Fastener note in Cautions and notes.

4. Hold the block in place and tighten the attachment bolt by hand.