Ignition Coil: Service and Repair
Removal Procedure1. Disconnect the negative battery cable.
2. Drain the cooling system.
3. Remove the heater supply and return hose.
4. Remove the coolant return hose.
5. Disconnect all four spark plug cables from the coil.
6. Disconnect electrical connector from the ignition coil.
7. Remove three mounting bolt from the ignition coil.
8. Remove the ignition coil from the bracket.
Installation Procedure
1. Install the ignition coil onto the bracket with three mounting bolts.
2. Connect electrical connector at the ignition coil.
3. Connect spark plug cable to the ignition coil.
4. Connect heater supply and return hose and secure them with clamps.
5. Connect coolant return line and secure them with clamps.
6. Fill the cooling system with required coolant.
7. Connect the negative battery cable.
Spark Plug Cable Routing