Ignition Control Module: Service and Repair

Ignition Module

Procedure #1

REMOVAL
1. Disconnect battery ground cable.
2. Ignition module connector.




3. Removal ignition module (1).

INSTALLATION




1. Install the ignition module (1).

Connect ignition module connector and ignition coil, then tighten bolt to the specified torque.

Torque: 20 N.m (15 lb ft)

2. Connect battery ground cable.

Procedure #2

Removal
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector from the ignition control module.
3. Remove the two attaching screws.
4. Remove the ignition control module from the engine block.

Installation
1. Fasten the module to the engine block with two screws.
2. Reconnect the electrical connector.




3. Reconnect the negative battery terminal.