Counter Shaft

DISASSEMBLED VIEW

DISASSEMBLY





1. Using a hydraulic press and bearing race receiver and case support J-37358, remove the counter shaft front bearing outer race (1). Remove the O-ring (1).





2. Remove the counter shaft front bearing (2) from the counter shaft (3). Use a hydraulic press, counter shaft front bearing remover J-37359 and bearing and gear puller J-22912-01.

REASSEMBLY





1. Install the counter shaft front bearing (2) onto the counter shaft (3), using a hydraulic press, installer J-37357 and bearing and gear puller J-22912-01.





2. Install a new O-ring (1) on the counter shaft outer race (1) and lubricate it.
3. Using installer and driver handle, lightly tap the outer race (1) into its bore until the O-ring is compressed.





4. Using a hydraulic press, installer J-37357 and driver handle J-8092, install the outer race (1) until its shoulder rests on the inside of the case.