Input Shaft

DISASSEMBLED VIEW

DISASSEMBLY
If you have not done so previously, remove these parts from the input shaft:
- Mainshaft thrust race (6), thrust needle bearing (5) and spacer (4)





- Mainshaft needle bearing rollers (3) (there are 15 rollers)





1. Using a hydraulic press and bearing and gear puller J-22912-01, remove the input shaft bearing (1) from input shaft (2).

REASSEMBLY





1. Use a hydraulic press, installer J-6133-1 and bearing and gear puller J-22912-01 to install the input shaft bearing (1) onto the input shaft (1).
2. Using petroleum jelly, install the 15 rollers (3) and spacer (4) into the rear of the input shaft (2). Also install the mainshaft thrust bearing (5) and its race (6) in the rear of the input shaft (2).