Windshield Wiper Arm/Blade

Removal




1. Pry the cap (2) off with the tip of a screwdriver.
2. Remove the nut.
3. Remove the wiper arm/blade (1).

Installation
To install, follow the removal steps in the reverse order, noting the following points:




1. Before installing the wiper arm/blade to the shaft, confirm that the motor stops at the autostop position.
2. Set the wiper arm/blade so that the tips of both blades are positioned about 40 mm (1.57 in) from the upper edge of the cowl cover as shown in the figure.
Tighten the nuts to the specified torque.
Torque: 23 N.m (17 lb.ft)