Torque Specifications

CYLINDER HEAD





Note: There is discrimination mark "R" for right bank and "L" for left bank on the cylinder head gasket as shown in the illustration. Do not reuse cylinder head gasket

- Align dowel pin hole to dowel pin on the cylinder block.
- Tighten two bolts temporarily by hand to prevent the cylinder head assembly from moving.





- Using J-24239-01 cylinder head bolt wrench, tighten bolts in numerical order as shown in the illustration to the specified torque.

Note: Do not reuse cylinder head bolts. Do not apply any lubricant to the cylinder head bolts.

Torque:
Temporary: 29 Nm (21 ft. lbs.)
Final: 64 Nm (47 ft. lbs.)

RELATED TORQUE SPECIFICATIONS





Cylinder Head Cover, Cylinder Head, Camshaft Bearing Cap, Common Chamber, EGR Valve and EGR Pipe, Ion Sensing Module,





Crankshaft Main Bearing, Flywheel, Crankcase, Oil Pan, Timing Belt Tensioner, Timing Pulley, Timing Belt Cover, Oil Pump, Oil Gallery, Oil Strainer and Water Pump





Connecting Rod and Water Pump





Engine Mount