Service Procedure

1. Remove the sun visor by removing the two (2) screws and disconnecting the harness (see figure 1).





2. Remove the inner front door seal and the front "A" pillar trim cover (see figure 2).





3. Remove the right and left front assist grips by opening the retaining bolt cover using a small screwdriver, proceed to remove assist grip retaining bolts (see figure 3).





4. Remove the B-Pillar trim by removing the upper retaining screw, the seat belt anchor cover and the seat belt anchor-retaining bolt (see figure 4).





5. Pull back the edge ofthe headliner to gain access to the roof pad cushion (see figure 5).

NOTE:
Headliner has been removed for illustration purposes and does not need to be completely removed for spacer installation.

6. New Pad Kit P/N 8-97362-625-0 contains two (2) long spacers and two (2) short spacers for installation on both driver and passenger sides roof pad cushion.





Long and short spacer will be attached to locations as outlined on figure 6.

NOTE:
Roof pad cushion has been removed for illustration purposes only and does not need to be removed to attach the spacers.





7. Remove the paper backing from the long and short spacer and affix to the roof pad cushion using figure 6 as a guide. When finished the long and short spacers MUST be located as shown on figure 7.

8. Reposition the headliner back in position.

9. Re-install the "B" pillar trim; reattach the seatbelt anchor and torque to 39 N.m (29 ft lbs).

NOTE:
The seat belt anchor retaining bolts MUST be torqued to 39 N.m (29 ft lbs).

10. Re-install the "A" pillar and door seal on both sides.

11. Re-install both driver and passenger assist grips.

12. Re-install both sun visors.