With TECH 2 Scan Tool

Tech 2 Scan Tool





From 98 MY, Isuzu dealer service departments are recommended to use Tech 2. Please refer to Tech 2 scan tool user guide.

Getting Started
^ Before operating the Isuzu PCMCIA card with the Tech 2, the following steps must be performed:
1. The Isuzu 98 System PCMCIA card (1) inserts into the Tech 2 (4).
2. Connect the SAE 16/19 adapter (2) to the DLC cable (3).
3. Connect the DLC cable to the Tech 2 (4).
4. Make sure the vehicle ignition is off.





5. Connect the Tech 2 SAE 16/19 adapter to the vehicle DLC.
6. The vehicle ignition turns on.
7. Power up the Tech 2.





8. Verify the Tech 2 power up display.

Operating Procedure








The power up screen is displayed when you power up the tester with the Isuzu systems PCMCIA card.
Follow the operating procedure above.

DATA LIST





The data displayed by DATA LIST are as shown.

ACTUATOR TEST














This mode is used to exercise the ABS actuators and make sure they operate normally. Prior to the test, pay attention to the cautions below. (When checking the solenoid valve system, be sure to jack up the vehicle.)

CAUTION:
^ Before testing, be sure that the brakes work normally.
^ Make sure that the battery is fully charged. Conduct the test by two persons (A TECH 2 operator and a vehicle checker).
^ Be sure to start ACTUATOR TEST with the engine stopped.
^ Before testing, make sure that electrical trouble, if any, has been completely repaired. Conducting tests of ABS solenoid with electrical circuit problem remaining uncorrected could damage the control unit.









Tech 2 Service Bleed