Accelerator Pedal: Service and Repair

Removal Procedure #1
1. Disconnect the negative battery cable.




2. Disconnect the electrical harness from the accelerator position sensor.




3. Remove the two screws from the accelerator pedal assembly.
4. Remove the accelerator pedal assembly from the bulkhead.

Removal Procedure #2




1. Disconnect battery ground cable.
2. Disconnect Accelerator position (AP) sensor (1) connector from Accelerator pedal assembly.
3. Remove Accelerator pedal assembly (2).

Installation Procedure #1
1. Install the accelerator pedal assembly on the bulkhead.




2. Install the two screws to the accelerator pedal assembly

Tighten
Tighten the screws to 22 N-m (16 lb ft.).




3. Connect the electrical harness to the accelerator position sensor.
4. Install the negative battery cable.

Installation Procedure #2
1. Install Accelerator pedal assembly (2).
2. Connect AP sensor (1) harness connector.
3. Connect battery ground cable.