Shift Cable: Service and Repair

Select Cable
Removal
1. Set selector lever in "P" position.
2. Remove knee pads, cluster upper cover, center cluster assembly, rear console, front console, selector lever knob and cover assembly.





3. Disconnect inner cable by pulling projection on pin.





4. Press down claws and disconnect cable assembly.
5. Remove nuts that fasten grommet in select cable assembly.





6. Disconnect inner cable.





7. Slide sleeve and disconnect cable assembly.





8. Pull lock.
9. Draw select cable assembly into the interior side.

Installation
1. Set selector lever in "P" position.
2. Let out select cable transmission side end from floor hole.





3. Fit outer cable into bracket in selector lever assembly.





4. Set inner cable end in selector lever and push pin into selector lever hole and inner cable end.





5. Check that lock projects.
6. Connect adjust end fitting attachment to the bracket on transmission.





7. Set select lever "P" position and connect inner cable to select lever.





8. Push lock into adjust end fitting attachment.
9. Install grommet.