Power Seat Assembly

Power Seat Assembly

Power Seat Assembly and Associated Parts:

Removal
1. Remove the adjuster bracket rear cover and the fixing bolts on the rear side of the seat adjuster assembly.
- Before removal, slide the power seat assembly forward.

2. Remove the adjuster bracket front cover and the fixing bolts on the front side of the seat adjuster assembly.
- Before removal, slide the power seat assembly backward.

3. Disconnect the battery ground cable.
4. Remove the power seat assembly.
- Disconnect the power seat harness connectors and the seat belt warning connector of the driver side.

CAUTION: When raising power seat assembly (1), use the handle (2) not the cable (3). A bent cable causes noise to occur during power seat operation.

- Please grip the handle (4).
- Don't grip the cable (5).







5. Pull the switch knobs out.
6. Remove the outer side cover.
- Remove the two fixing screws and disconnect the power seat switch connector.

7. Remove the power seat switch.
- Remove the two fixing screws.

8. Remove the power lumber switch.
- Remove the two fixing screws and connectors.

9. Remove the inner side cover.
10. Remove the headrest.
11. Remove the reclining device (2).
- Flip up the seat back trim cover (1) in order to remove the reclining device fixing bolts.
- Disconnect the reclining motor harness connector (3).







12. Remove the reclining device covers.
13. Remove the trim cover and pad (Seat back side).
14. Remove the seat heater and connector (seat back side).
15. Remove the power lumbar support assembly.
16. Remove the guide holder.
- Pull the guide holder out by holding the bottom end of it from the seat back assembly.

17. Remove the seat adjuster assembly.
- Remove the four fixing bolts and disconnect the sliding motor connector.

18. Remove the sliding motor cable (2).
- Remove the nuts of each side.

CAUTION: Be sure to maintain the same position for both outer and inner seat adjust assembly (1).







19. Remove the seat belt buckle assembly.
20. Remove the trim cover and pad (Seat cushion side)
21. Remove the seat heater and connector (Seat cushion side).
22. Remove the power seat hamess.

Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Tighten the reclining device fixing bolts to the specified torque.
Torque: 46 N.m (34 lb ft)

2. Tighten the seat adjuster fixing bolts to the specified torque.
Torque: 21 N.m (15 lb ft) to seat cushion
Torque: 39 N.m (29 lb ft) to body

3. Tighten the seat belt buckle assembly fixing bolts to the specified torque.
Torque: 29 N.m (22 lb ft)