Power Door Lock Switch: Service and Repair
Door Lock Key SwitchRemoval
1. Disconnect the battery ground cable.
2. Remove the power window switch (1)/regulator handle.
- Pry out the power window switch and remove the connectors.
- To remove the regulator handle (1), remove the clip (2), at the root of the handle by using wire with hook.
3. Remove the screw while pulling the inside lever toward you and then remove the inside handle.
4. Remove the speaker grille (1).
- Pull out the front side of the grille.
5. Remove the speaker assembly (2).
- Remove the 4 screws and disconnect the speaker harness connector (3).
6. Remove the courtesy light lens.
7. Remove the 5 screws (1), (3) and pull out the door trim panel at the 6 clip (2) positions.
8. Remove the waterproof sheet.
- Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.
9. Raise the glass up to the uppermost position, and then remove the rear guide rail.
10. Disconnect the locking links then remove the door lock assembly fixing screws and door lock assembly.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Apply chassis grease to the lock assembly and striker moving surface.
2. Install the regulator handle as shown in the illustration, if equipped without power windows.
3. Tighten the door lock assembly fixing screws to the specified torque.
Torque: 7 N.m (61 lb in)
4. Check that the door lock operates smoothly.