Rear Quarter Glass (LWB)

Rear Quarter Glass (LWB)

Parts Location:

Removal

1. Disconnect the battery ground cable.
2. Remove the rear quarter trim panel.
3. Remove the rear quarter glass.

Installation

1. Rear quarter glass.
- Clean the bonding surfaces of both the glass and the body panel.
- Be absolutely sure to apply glass primer to the side glass.
- Be absolutely sure to apply body primer fully to the body.

NOTE: Immediately wipe off the primer left on the body or extruded sealant.

- Attach the fastener to the indicated position of body with sealant as shown in the figure.
- Apply the sealant to the circumference of glass as shown in the figure.
- Insert the location pins on glass into the panel, push the glass against the panel, and bond them.
- Attach the molding to the body with sealant.
- Cure the bonding at a temperature of 20 °C -30 °C (68 °F -86 °F) for 24 hours.
- Check the rear quarter glass for any signs of water leak.

2. Install rear quarter trim panel.