Rear Wiper Motor (Resin Top Model)

Removal

1. Disconnect the battery ground cable.
2. Remove the tailgate trim pad.
3. Remove the wiper arm/blade. Refer to Rear Wiper Arm/Blade (Resin Top Model).




4. Remove the rear wiper motor (1).
- Disconnect the connector.
- Remove the rear wiper shaft nut and the rear wiper motor fixing screws.

Installation

To install, follow the removal steps in the reverse order, noting the following points:
1. Before installing the wiper arm/blade to the motor shaft, confirm that the motor stops at the autostop position.




2. Install the wiper arm/blade (1) on the hatch gate as shown in the figure.
3. Tighten the motor shaft nut to the specified torque.

Torque: 7 N.m (61 lb in)

4. Tighten the wiper arm nut (2) to the specified torque.

Torque: 11 N.m (95 lb in)