Antitheft and Alarm Systems: Service and Repair
Anti-theft & Keyless Entry Control UnitRemoval
1. Disconnect the battery ground cable.
2. Remove the front console assembly.
- Refer to the Instrument Panel Assembly in Body Structure.
3. Remove the lower cluster assembly.
- Refer to the Instrument Panel Assembly in Body Structure.
4. Disconnect the connector (2).
5. Remove four screws to remove the anti-theft & keyless entry control unit with bracket (1).
6. Remove two nuts from the anti-theft & keyless entry control unit with bracket (3) to remove the anti-theft & keyless entry controller (4).
Installation
To install, follow the removal steps in the reverse order.
Anti-Theft & Keyless Entry Control Unit/Transmitter Replacement
Anti-Theft & Keyless Entry Control Unit Replacement
1. Remove and install the control unit.
- Refer to Anti-theft & Keyless Entry Control Unit Removal and Installation.
2. Register ID code.
- Refer to ID Code Registration in this section.
3. Check that the keyless entry system works normally.