Power Seat Assembly

Power Seat Assembly

Disassembled View:

Disassembly

1. Disconnect the battery ground cable.
2. Remove the head rest.
3. Remove the switch knob.
- Pull the switch knob out.

4. Remove the outer cover cap.
5. Remove the outer cover fixing screws.
- Pull up the outer cover(1) to remove the cover from the reclining device(2).







6. Remove the front cover.
7. Remove the front lower cover.
8. Remove the rear cover.
9. Remove the outer cover.
- Disconnect the switch connectors and remove the harness fixing clips.

10. Remove the switch assembly.
- Remove the switch fixing screws from the outer cover.

11. Remove the armrest assembly.
- Open the armrest fastener and remove the fixing bolt.







12. Remove the trim cover.
13. Remove the pad & frame assembly.
14. Remove the inner cover
- Remove the cover fixing screw.
- Pull up the inner cover to remove the cover from the reclining device(3).







15. Remove the back board assembly(4).
- Remove the board fixing screws.
- Pull the back board downward and remove the board from the seat back frame(5).







16. Remove the reclining device(7).
- Remove the device lower side fixing bolt in order to separate the seat back from the seat cushion.
- Disconnect the seat heater connector.
- Remove the trim cover(6) hog rings from the backside of the seat back assembly.
- Turn up the seat back trim cover to remove the reclining device upper side fixing bolt.
- Disconnect the connecting shaft and the reclining device connectors.







17. Remove the seat back assembly.
18. Remove the guide holder(8).
- Remove the trim cover fixing hog rings(9) from the backside of the seat back assembly.
- Hold the tip end of the guide holder and pull the holder out from the seat back assembly.







19. Remove the trim cover.
- Remove the trim cover hog rings from the backside of the seat back.
- With close attention paid to the hog rings and the wire which connect the trim cover and pad & frame assembly, remove the trim cover while turning it up.

20. Remove the seat heater.
21. Remove the pad assembly.
22. Remove the frame assembly.
23. Remove the outer lower cover.
24. Remove the inner lower cover.
25. Remove the adjuster assembly.
- Disconnect the connectors and remove the fixing bolts.
- Remove the power seat harness from the adjuster assembly.

26. Remove the seat cushion assembly.
27. Remove the trim cover.
- Remove the trim cover hog rings from the backside of the seat cushion assembly.
- With close attention paid to the hog rings and the wire which connect the trim cover and the pad & frame assembly, remove the trim cover while turning it up.

28. Remove the seat heater.
29. Remove the frame assembly.
30. Remove the pad assembly.

Reassembly

To reassemble, follow the disassembly steps in the reverse order, noting the following point.
1. Tighten the fixing bolts to the specified torque.