Input Clutch Assembly Disassemble
Input Clutch Assembly DisassembleRemoval Procedure
Tools Required
^ J23327-1 Clutch Spring Compressor
^ J23456 Clutch Spring Compressor Press
^ J25018-A Clutch Spring Compressor Adapter
1. Remove the reverse input clutch housing and drum assembly (605) from the input clutch assembly (621).
2. Remove the stator shaft/selective washer bearing assembly (615).
3. Remove the selective thrust washer (616).
4. Remove the 3rd and 4th clutch backing plate retainer ring (656).
Important: The 3rd and 4th clutch plate stack is different for 2.2L models.
Important: The M30 RPO3-4 clutch plate stack up is application specific. The stack up on a 2.2L S/T platform is 5 fiber plates, and 6 fiber plates on all other models. The M32 RPO (heavy-duty design) uses 7 fiber plates. These fiber plates are a thinner thickness which can not be used in a M30 stack up. M32 fiber plates must not be used in a M30 design.
Notice: The correct fiber plates must be used to avoid damage to the transmission. An incorrect stack up height can cause either excessive clutch slippage or insufficient release, resulting in burned clutch plates.
5. Remove all 3rd and 4th clutch plates (653-655).
6. Remove the 3-4 clutch boost spring assemblies (600).
7. Remove the forward clutch backing plate retainer ring (651).
8. Remove the forward clutch selective backing plate (650).
9. Remove the forward clutch sprag assembly.
10. Remove all forward clutch plates (646, 648, 649A, 649B).
11. Remove the input sun gear bearing assembly (637).
12. Remove the input housing to output shaft seal (636).
13. Remove all overrun clutch plates (645A, 645B).
14. Install the J23327-1 and the J25018-A.
15. Compress the overrun clutch spring, using the J23456.
16. Remove the overrun clutch spring retainer snap ring (635).
17. Remove the J23327-1 and the J25018-A.
18. Remove the overrun clutch spring assembly (634).
19. Remove the overrun clutch piston (632).
20. Remove the forward clutch piston (630).
21. Remove the forward clutch housing (628).
22. Remove the 3rd and 4th clutch spring assembly (626).
23. Remove the 3rd and 4th clutch apply ring (625).
24. Remove the 3rd and 4th clutch piston (623).