Positive
Battery Positive Cable ReplacementRemoval Procedure
1. Disconnect the negative battery cable (5).
2. Disconnect the positive battery cable (4).
3. Loosen the positive terminal bolt (1) that secures the harness to the junction block.
4. Reposition the generator cable boot (1).
5. Remove the generator cable nut (2).
6. Remove the generator cable lead (3).
7. Open the clips on the retaining brackets.
8. Remove the battery cable channel bolt.
9. Remove the battery cable channel.
10. Remove the battery cable from the channel.
11. Remove the positive cable lead nut (2) from the starter.
12. Remove the positive cable lead (1).
13. Remove the cable clip (3) from the bracket.
14. Remove the starter solenoid lead nut (2).
15. Remove the starter solenoid lead (1) from the starter.
16. Remove the battery cable from the conduit.
Installation Procedure
1. Install the battery cable to the conduit.
2. Install the starter solenoid lead (1) to the starter.
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Install the starter solenoid lead nut (2).
Tighten:
Tighten the nut to 3.4 Nm (30 lb in).
4. Install the cable clip (3) to the bracket.
5. Install the positive cable lead (1).
6. Install the positive cable lead nut (2) to the starter.
Tighten:
Tighten the nut to 9 Nm (80 lb in).
7. Install the battery cable to the channel.
8. Install the battery cable channel.
9. Install the battery cable channel bolt.
Tighten:
Tighten the battery cable channel bolt to 12 Nm (106 lb in).
10. Install the generator cable lead (3).
11. Install the generator cable nut (2).
Tighten:
Tighten the nut to 9 Nm (80 lb in).
12. Position the generator cable boot (1).
13. Close the clips on the retaining brackets.
14. Tighten the positive terminal bolt (1) that secures the harness to the junction block
Tighten
Tighten the bolt to 10 Nm (89 lb in).
15 .Connect the positive battery cable (4).
Tighten:
Tighten the positive cable to 15 Nm (11 lb ft).
16. Connect the negative battery cable (5).