Rear

LH/RH

Removal
1. Disconnect the battery ground cable.
2. Disconnect the connector (1) from the harness and remove the connector (1) from the bracket (4).
3. Remove the clip (2).
4. Remove the rear shock absorber (3).
5. Disconnect the connector (10) from the harness and remove the connector (10) from the gusset (11).
6. Remove the 2 bolts (5).
7. Disconnect the G-sensor (6).

Inspection and Repair
Refer to Shock Absorber; Service and Repair.

Installation
1. Set the G-sensor on the gusset (11).
2. Install 2 bolts (5) then tighten it to the specified torque.
Torque: 7 Nm (61 inch lbs.)
3. Connect the connector (10) to the harness and insert the connector (10) to the gusset (11).
4. Install the rear shock absorber (3).
5. Connect the connector (1) to the harness and insert the connector (1) to the bracket (4).
6. Insert the clip (2) to the bracket (4).
7. Connect the battery ground cable.