Front Door Window Glass: Service and Repair

Front Window Regulator, Glass and Glass Run

Parts Location:

Removal
1. Disconnect the battery ground cable.
2. Remove the pull box.
- Remove the one fixing screw.







3. Remove the power window switch (1).
- Pull the power window switch and remove the connector.







4. Remove the inside handle.
- Open the screw cover (1) and remove the screw.
- Disconnect the cable.







5. Remove the door mirror cover.
6. Remove the trim panel at the 8 clip positions (1).
- Disconnect the tweeter and courtesy light connectors.







7. Remove the inner waist seal.
8. Remove the tweeter.
9. Remove the courtesy light.
10. Remove the pull box bracket.
11. Remove the inside lock bracket.
- Disconnect the cable.

12. Remove the speaker (2) and speaker spacer (1).
- Disconnect the speaker connector (3).







13. Remove the waterproof sheet.
14. Remove the outer waist seal.
- Remove the rear side screw and pull the outer waist seal upward.

15. Remove the window glass.
- Operate the regulator (power window switch) to adjust the glass height and expose the access hole. Remove the 2 bolts fixing the bottom channel and the regulator. Remove the glass.










16. Remove the window regulator.
- Remove the 7 fixing bolts and disconnect the window regulator motor harness connector.

17. Remove the glass run.
- Pull the glass run (6) from the door frame.







Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Check to see that the window regulator operates smoothly and the glass opens and closes properly.
2. Install the waterproof sheet tightly against the door panel.
3. Tighten the window regulator assembly fixing bolts to the specified torque.
Torque: 6 N.m (52 lb in)